Unconfigured Ad Widget

Collapse

Resolved

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • peterabbits
    • Apr 2010
    • 1266

    Resolved

    Just finished assembling my 80% lower - minus the grip, because I could not for the life of me to get the screw more than a few threads into the receiver - any suggestions as to how to resolve (solutions requiring a minimum of tools to be purchased would be preferred.)

    Thanks in advance for your help!
    Last edited by peterabbits; 04-11-2012, 10:15 PM.
  • #2
    bohoki
    I need a LIFE!!
    • Jan 2006
    • 20826

    are you sure you have the right screw

    sometimes the coatings are really thick and you may need to chase the threads with a tap

    Comment

    • #3
      bohoki
      I need a LIFE!!
      • Jan 2006
      • 20826

      are you sure you have the right screw

      sometimes the coatings are really thick and you may need to chase the threads with a tap

      Comment

      • #4
        cj cake
        Senior Member
        • Dec 2006
        • 1370

        Pete, I'll take care of it for you. The anodized TM Ar15s have crud built up in the screw hole. We just run a tap through there now to clean up the crud. We are running Ar10 this weekend now too. Just a heads up.

        Comment

        • #5
          Tripper
          Calguns Addict
          • Jan 2011
          • 7628

          i used a grip screw from a hammerhead grip, the one from a PSA lower kit would not fit it
          WTB NAA Belt Buckle
          MILITARY STRETCHER/RADIATION DETECTION KIT

          Comment

          • #6
            peterabbits
            • Apr 2010
            • 1266

            Thanks Jason! I'll bring the completed lower with me Saturday morning then to take care of it while milling out the Quentin lower. I'll have to review my budget as I might want to do one of the .308 lowers Saturday too then.

            Comment

            Working...
            UA-8071174-1