Status on RPK Romy flats?

[Roccobro]

Curtis (AK Builder) may be running into inventory issues and time constraints. LOL

We Californians are keeping him busy.

Yesterday, we had a build party for 8 Marines from Pendleton, and two Romy RPK builds were done. Another Marine had a Curtis parts kit that had been populated and headspaced, but none of the pin holes, including the barrel pin, was drilled. No gas port either.

We took care of him though.

I'm glad you took care of those Marines. I sure felt bad telling them "no house calls" with my busy schedule.

Justin

[mrlonewolf]

I'm glad you took care of those Marines. I sure felt bad telling them "no house calls" with my busy schedule.

Justin

I was honored to be there and have/ take a personal approach with that specific case.

I'd dedicate a lot of time with that " ready to build kit".


The worst POS that I've ever seen in my entire life. But at the end of the day everything was fine.


Can't deny the fact that at one point I'd asked 69Mach1,Caiman and Wtsgdygtbr to look away so I can perform my Magic....... Yup. it was that drastic.



Curtis... Curtis, I know you are reading....please PM if you would, care or dare...

Thank you.

[mrlonewolf]

Yesterday, we had a build party for 8 Marines from Pendleton.

Glad to have more than 10 in the house.

A big Thank you goes to our USMC troops who attended the BP.

[valley82]

AKTEAM...you guys rock...taking care of the boys that allow us the freedom to build these ourselves.

[n2k]

I'm glad that BP went well. Thank you guys for helping these honorable service men engage in their 2A rights that they fight for.

Also, thank you for all your knowledge and assistance you bestowed on me. The shoot went well and the RPK'S looked great.