Unconfigured Ad Widget

Collapse

Kimber problem. Thoughts?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • bruceflinch
    I need a LIFE!!
    • Jan 2006
    • 40179

    Kimber problem. Thoughts?

    My Buddy bought a Kimber 45 compact.
    We were test firing it Sunday for the first time. We had a factory 7 round mag & a Wilson 7 round mag. Both Mags worked fine.

    However, 5 times out of 60 rounds, the hammer fell & the firing pin did not strike the primer w/ enough force to cause a discharge. It happened on the first round as well as halfway thru the rounds in the mag. In 3 cases the mark from the firing pin was barely discernable. 2 cases had dimples about half as deep as a standard dimple.

    Anyones thoughts on the issue?

    My Buddy is sending the gun back & will wait 4-6 weeks to get it returned. This is after he waited 2.5 months to get it. Bummer.
    Actually I only started collecting Milsurps 3 years ago. I think I might own about 24...They're cheaper than guns that will most likely never get the opportunity to kill somebody...

    I belong to the group that uses firearms, and knows which bathroom to use.

    Tis better to have Trolled & lost, Than to never have Trolled, at all.

    Secret Club Member?.
  • #2
    vmwerks
    Norcal Cyclist
    CGN Contributor - Lifetime
    • Jun 2009
    • 3502

    I would check the hammer spring to make sure it moves smoothly in the housing. The intermittent nature would cause me to start there. The other remote possiblity is that the slide was just a few thousandths shy of complete lockup. In any case the gun should be returned IMO.

    I had a Colt tanker model many years ago, it had an inner and outer recoil spring. I had a few issues with lower weight rounds IIRC. It believe it took 230 gr well.

    Comment

    • #3
      cmace22
      Veteran Member
      • Jan 2008
      • 2717

      If its a new Kimber, I would make sure that the series II safety is disengaging properly. If the grip safety isnt depressed enough the firing pin block will stop the firing pins forward movement. The issue may be in the grip safeties interaction with the disconnecter and firing pin block or simply a grip issue with the shooter.
      Last edited by cmace22; 03-01-2011, 9:36 AM.

      Comment

      • #4
        bruceflinch
        I need a LIFE!!
        • Jan 2006
        • 40179

        Al is sending it back. He got an RTA already.

        I also noticed the hammer would fall when the slide was not all the way forward.
        Actually I only started collecting Milsurps 3 years ago. I think I might own about 24...They're cheaper than guns that will most likely never get the opportunity to kill somebody...

        I belong to the group that uses firearms, and knows which bathroom to use.

        Tis better to have Trolled & lost, Than to never have Trolled, at all.

        Secret Club Member?.

        Comment

        Working...
        UA-8071174-1