922r NooB Question

[sindominator]

If you use a "milled" receiver for an AK either 47 or 74, does that count as 3 922r parts? Since you are not using the original imported front trunion or and rear trunion???

[69Mach1]

The receiver counts as one of the parts for 922r whether it's a stamped or a milled rec.

[nicoroshi]

There is no trunnions on a milled receiver (front or rear).
Hence there are only 15 countable parts on a milled AK build (with muzzle device).
If the milled receiver was produced in the US then of course it counts as 1 US made part.
If the receiver was re-welded from scrap steel (after a kit is demilled to BATF standards it 'is' considered scrap steel) then it becomes a US made piece.
Hope that helps.

[sindominator]

Man, I love this site! The answers I need, instantly.

Thank you gentlemen!
-gus

[five.five-six]

The receiver counts as one of the parts for 922r whether it's a stamped or a milled rec.

just so long as it's made in america