Unconfigured Ad Widget

Collapse

HELP!

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • packnrat
    Veteran Member
    • Feb 2007
    • 3939

    HELP!

    i kinda got turned around and installed the roll pin into the ar lower in the wrong hole. (the blind one).

    any out there know of a way to get it out so i can do the job right?

    tried locking pliers. even with a "tool" inserted so as to not just crush it.

    how can one "lock" onto the roll pin and get it to be pulled out?


    .
    big gun's...i love big gun's
  • #2
    BSlacker
    Senior Member
    • Dec 2003
    • 923

    Thread it put a screw in it and use a sleeve and nut to pull it out. Or nuke it from space.

    Comment

    • #3
      packnrat
      Veteran Member
      • Feb 2007
      • 3939

      just as long as it does not "expand" the roll pin....might work.
      as for nuking from orbit. sorry but i am out of nukes right now.
      and my shuttle is in the shop for brakes.
      big gun's...i love big gun's

      Comment

      • #4
        BSlacker
        Senior Member
        • Dec 2003
        • 923

        If you can get a good four turns with a bottom tap and use a proper fitting small bolt with the end ground square. Then use some epoxy on the bolt as it is turned in, let it set for 24 hrs. That should give enough purchase on the roll pin without spreading it.
        My shuttle is in the shop for minor electrical problems. When I honked the horn the doors locked. Go figure.

        Comment

        • #5
          NeoWeird
          Veteran Member
          • Dec 2005
          • 3342

          Before you potentially mess anything up, ask yourself this one question:

          If it ain't broke, why fix it?

          Seriously. You're going to potentially invest $20+ to correct a problem that won't affect anything on a $100-150 part. That said, if you HAVE to make it right, chop the trigger guard close to the pin, cut it lengthwise, remove trigger guard pieces and push the pin out with some needle nose pliers. You'll replace the trigger guard and roll pin, but you won't risk epoxying the pin inside the receiver or snapping taps off in the tempered spring steel roll pin.
          quemadmodum gladius neminem occidit, occidentis telum est. - Lucius Annaeus
          a sword never kills anybody; it's a tool in the killer's hand.

          Comment

          • #6
            packnrat
            Veteran Member
            • Feb 2007
            • 3939

            true spending 20 usd for fixing a "non" broken part, but the pin does not go down flush with the receiver it sticks out just enough to be a problem.
            i had thought about the hack and slash on the guard, but was hoping there was some trick out there.
            but stupid shff, does cost money to fix right.
            a light touch with the dremel grinding tool and it would work with no problem.
            would giver me a chance to use some of the junk in the case that's been sitting for years with no use.

            .
            big gun's...i love big gun's

            Comment

            • #7
              Roccobro
              Veteran Member
              • Feb 2007
              • 2907

              Insert a drill bit the same OD as the pins ID then clamp with a strong/sharp set of vise grips.

              Justin
              For any questions contact me by email.
              Thanks,
              Justin
              Originally posted by ar15barrels
              Sometimes, arguing just for the sake of arguing, can be fun.
              Originally posted by DannyZRC
              no it can't!
              Originally posted by ar15barrels
              YES IT CAN!
              "Pink rifle disease... SPREAD IT!"

              Comment

              Working...
              UA-8071174-1