Unconfigured Ad Widget

Collapse

Free Float Rail Install Help

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Jel
    Senior Member
    • Mar 2009
    • 1425

    Free Float Rail Install Help

    Hey guys,

    I'm finally getting around to changing the standard 2 piece guards on my rifle length AR with a 12" free floater from Midwest Industries.

    I know I have to remove the front sight and flash hider.

    I know that Brownells (and others) have blocks that can help with the removal of the front sight as well as vise adapter blocks that assist with holding the upper receiver when working on AR's.

    I'm all for using the right tools for the job. However, I'd rather not spend $70+ on these blocks and adapters if I'm only going to use them once.

    What other methods are there for FS removal? Can I get away with a small block of wood cut to the right thickness?

    For holding the upper to mount the rail, can I pad the vise with a towel/rag and try it that way?

    Any help or suggestions are very much appreciated.

    Thanks guys!

    Jel
  • #2
    damon1272
    Veteran Member
    • Aug 2006
    • 4858

    You could do it with a block of wood and drill a couple of holes for the pins to drop out. As for the barrel nut my RRA was a cinch. For my BCM uppers I had to by an action block as they are TIGHT! I would suggest the Brownells action block or find someone to install it for you.

    Comment

    • #3
      rero360
      Veteran Member
      • Dec 2009
      • 3927

      I second that you can get away with not using the FSB block thingy but I would highly recomend getting an action block so you don't bend/crush, or distort the upper in any other fashion while its in the vise.

      Comment

      Working...
      UA-8071174-1