Need template for AK pre-bent build

[Charlie50]

Hey guys I'm looking for a free, yeah I know I'm cheap, downloadable 1:1 template for a Romanian AK project I'm working on. The blank I have is pre bent. My plan is to print out and adhere to the receiver. It would be nice if it was "spot on" accurate and takes in account the radius of the lower bends (so it can be wrapped around in one piece). I've looked around this site and the web with only moderate success... well for free stuff . Thanks in advance.

[tujungatoes]

seen these?

[Charlie50]

Thanks for the lead but I could not get the template to print in the proper size. I guess it will take some tweaking. Any other input would be appreciated.

seen these?

[Charlie50]

Thanks Got It!

seen these?

Thanks tujungatoes, I just had to play with printer/ computer settings, and get 8.5 X13 paper. FYI Placed on top of AK Builder flat and all matches, maybe a little tight at the mag well width.

[SJgunguy24]

Thanks tujungatoes, I just had to play with printer/ computer settings, and get 8.5 X13 paper. FYI Placed on top of AK Builder flat and all matches, maybe a little tight at the mag well width.

If you have a flat what do you need a template for? You have one right there.
Measure a center line and pull everything from that.

[Roccobro]

I think you'll save yourself a METRIC TON of grief by buying an AK-Builder.com flat.

I'm sure after two folds you'll be thanking your lucky stars you didn't "save" the $19 they cost, but saved the DAYS and aggravation a flat-flat build involves.

You want the completed gun to look and work right, right?

Justin

[tujungatoes]

Thanks tujungatoes, I just had to play with printer/ computer settings, and get 8.5 X13 paper. FYI Placed on top of AK Builder flat and all matches, maybe a little tight at the mag well width.

glad you got it worked out, but i have to agree with Roccobro. why go about it the hard way? Is it just one of those "cause i can" things?

[sava6e]

Have you tried biggerhammer.com?

[bigthaiboy]

Hey guys I'm looking for a free, yeah I know I'm cheap, downloadable 1:1 template for a Romanian AK project I'm working on. The blank I have is pre bent. My plan is to print out and adhere to the receiver. It would be nice if it was "spot on" accurate and takes in account the radius of the lower bends (so it can be wrapped around in one piece). I've looked around this site and the web with only moderate success... well for free stuff . Thanks in advance.

You bought one of these 80% AK receivers, didn't you?

http://www.coldsteelsolutionsincorporated.com/csi,_inc_003.htm