Trigger diameter problem (not a newbie question)

[MissionMTMan]

Okay. I don't know if you guys will be able to help me or not but here goes. I have a Colt lower with a sear block. My colt lower has the large pin (.169"). Since it has the large pin AND sear block; what can I do in terms of good aftermarket triggers? This is a statement off of Larue Tactical:

From Larue Tactical:

NOTE: Colt receivers with large pins (.169" dia) require our Large Pin Trigger. The Large Pin Trigger will not work in a lower that has a Sear Block. Some early Colt receivers and all other branded receivers (Bushmaster, Armalite, Rock River, Olympic Arms, Eagle Arms, PWS, Stag, CLE, etc) use the small pin (.154" dia) that this Small Pin Trigger is designed for.
This

Missionmtman

[MissionMTMan]

cricket cricket..... Any help guys?

I think I have no other solution except to get a new lower....

[kendog4570]

When the Krieger/Milazzo triggers first came out, the sear block in some of the big hole Colts had to be cut or ground away to make clearance for ther trigger tail. Don't know why that wouldnt work on the LaRue (or any other trigger needing clearance).

[-hanko]

cricket cricket..... Any help guys?

I think I have no other solution except to get a new lower....

Easiest is to remove the sear block, or cut & grind until the trigger drops in.

-hanko

[kendog4570]

Easiest is to remove the sear block, or cut & grind until the trigger drops in.

-hanko

Used to do it all the time.

[MissionMTMan]

I think I am just going to sell the colt lower and get a Mega. Thanks for the help guys.