Unconfigured Ad Widget

Collapse

Offset hinge pin

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Pofoo
    Senior Member
    • Dec 2009
    • 1693

    Offset hinge pin

    A Colt AR Sporter RAW and a Bushmaster upper requires a offset front hinge pin.
    Is there any reason that this combo couldn't be machined to accept a streight pin?
    Any legal problems?
    The holes are offset and of different sizes but the smaller one is definately inside the larger one, it just needs to be enlarged on 1 side. If they had the same centers, it would be easy just to drill to match, but I think it would be best to have it machined by a competent machinist so that they line up correctly.
    If there are no problems with this, can anyone recommend a GOOD gunsmith/machinist in the N. Orange County/Long Beach area?
  • #2
    ar15barrels
    I need a LIFE!!
    • Jan 2006
    • 57198

    Your bushmaster upper has a normal 1/4" hole and your non-standard Colt has the large offset pin right?
    You are looking to open up the bushmaster's upper reciever to use the Colt lower with a larger diameter Colt pin right?

    If so, I can probably do it.
    Randall Rausch

    AR work: www.ar15barrels.com
    Handguns: www.handgunbarrels.com
    Bolt actions: www.700barrels.com
    Foreign Semi Autos: www.akbarrels.com
    Most work done while you wait on a scheduled shop visit.

    Comment

    • #3
      Pofoo
      Senior Member
      • Dec 2009
      • 1693

      AR15 Barrels---PM sent

      Comment

      Working...
      UA-8071174-1