Blueprint or template for 80% ak receiver?

[Z ME FLY]

Hey guys, so I got an 80% receiver with my AMD. I figure, I can at least get started on some of it since I built the AMD into a pistol already. It looks like a flat bent with no holes at all. Basically it has a dimple, a dent where you are suppose to cut out the safety, cut in the rear for the side folding stock and a small punch hole where you are suppose to drill the other three holes. I tried to look online for a template of a blueprint of somekind that I can use as a guide for my dremel to start cutting out. Oh yeah BTW, If I use an AMD receiver like this with the rear trunnion, do I have to stick with a AMD front end? or can I make it a bastard with some other combo? Yugo or romy front end?

Thanks!

[416stroker]

http://www.gunco.net/forums/f163/ace-arms-ak-47-template-updated-727/

you can change front trunnions as well it wont matter

[Z ME FLY]

Thanks, if I mess it up, no biggie since I got it for free basically.

[uxo2]

http://pookieweb.dyndns.org:61129/AK/docs/templates.htm

[Z ME FLY]

Thanks Fredie, gives me some ideas

I saw the PM you sent me, I would have gotten that just because I know I would use it in the future but no room where I am at.