Unconfigured Ad Widget

Collapse

Casting a chamber

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Savage99
    Junior Member
    • Dec 2009
    • 10

    Casting a chamber

    I would like to know how do you cast a chamber to do all of the necessary measurements for the brass and others measurements. I know you need to get the casting alloy that melts at around 170 degrees or so, but how do you do it?
  • #2
    gunboat
    Veteran Member
    • Apr 2008
    • 3288

    Melt the cerro-safe or cerro-bend in double boiler fashion - that is a small container suspended in a cooking pot of water.
    Plug the bore about 1/2 inch or so ahead of the throat. I use a patch or wad of paper. Remove the bolt if practical or block open to prevent interference.
    A small funnel with a bit of tubing attached will guide the melt into the chamber. DO NOT pour in enough melt to get into the locking lugs. Use just enough melt to fill chamber --
    When melt solidifies, about 2-3 minutes, tap it out with a cleaning rod -- Depending on the composition of your casting material, it will shrink a few thou when it first cools - which makes it easy to remove -- then it returns to exact size in about 24 hours.
    It will likely be wrinkled in a few places but that is usually of no matter. Warming the receiver can prevent the wrinkles but it is often not practical.
    I think that is about it -- My ha-penny

    Comment

    • #3
      mofugly13
      Senior Member
      • Mar 2009
      • 885

      You get the alloy, and then follow the directions that come wth it.

      First you plug the bore just ahead of the chamber with a tight patch on a jag, then you eat the chamber area of the barrel up until it's almost too hot to touch. Then you melt some of the alloy and pour it into the chamber, without overflowing it. After 20 minutes of cooling time, as soon as the barrel is cool to barely warm, you can drive the cast out with a cleaning rod. If you mess up, you can re-melt the alloy and try again. This process works best with the barrel remved from the rifle, but that is not always practical. You may need to devise a funnel or some sort of tube or chute to guide the molten alloy into the chamber.
      No government deprives its citizens of rights without asserting that its actions are "reasonable" and "necessary" for high-sounding reasons such as "public safety."
      A right that can be regulated is no right at all, only a temporary privilege dependent upon the good will of the very government
      officials that such right is designed to constrain.

      Comment

      Working...
      UA-8071174-1