Unconfigured Ad Widget

Collapse

Relieving trigger guard

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Glock22Fan
    Calguns Addict
    • May 2006
    • 5752

    Relieving trigger guard

    Both my Glocks and my (scandium framed) 1911 could do with a bit of easing where my middle finger meets the trigger guard. I'd like to take the bottom of the trigger guard off at a slight angle (maybe 15 degrees) with the material removed at the RHS.

    I'm guessing that the polymer Glocks are self-colored, and it might be possible to do them with a Dremel with care, but that the 1911 frame might need re-finishing afterwards.

    Can anyone with experience tell me whether this is something I should leave for a gunsmith for either, or both, models? If so, what are typical costs for this sort of work? Any other thoughts?

    Thanks!
    John -- bitter gun owner.

    All opinions expressed here are my own unless I say otherwise.
    I am not a lawyer and this is not legal advice.

    sigpic
  • #2
    ar15barrels
    I need a LIFE!!
    • Jan 2006
    • 57200

    Like this?



    It works great to lower the gun down in your hand some more.
    Randall Rausch

    AR work: www.ar15barrels.com
    Handguns: www.handgunbarrels.com
    Bolt actions: www.700barrels.com
    Foreign Semi Autos: www.akbarrels.com
    Most work done while you wait on a scheduled shop visit.

    Comment

    • #3
      Glock22Fan
      Calguns Addict
      • May 2006
      • 5752

      Yea, that looks good, but I need relief more on the other side.

      With the web between my thumb and the rest of the digits well up in the beavertail, my middle finger comes down at an angle, hard up to the guard at the rhs (the body side) but there's a visible gap at the lhs (fingertip side). A day at the range, and my finger hurts!

      Thinking about it, because of the beavertail, I doubt I'd get a higher grip, but it would sure be nice to lessen the effect of recoil on my finger.
      Last edited by Glock22Fan; 01-13-2010, 2:52 PM.
      John -- bitter gun owner.

      All opinions expressed here are my own unless I say otherwise.
      I am not a lawyer and this is not legal advice.

      sigpic

      Comment

      Working...
      UA-8071174-1