Tweet
I measured the extracter height on my rem 721 using solder. Squared up a tiny piece of solder into a small block. Tapped the block into space between bolt face and extarcter, then eased it out with a pin. Measured .058, to small for a 6.5x55 case.
-
-
and the point is??????Screw the environment! The sooner we trash this place the sooner we will have the political will to explore space and conquer the known universe, spreading like locust we will plunder, crush new enemies, take their women and if we are lucky, we shall meet our fate on the battlefield.
Faust. -
Randall Rausch
AR work: www.ar15barrels.com
Handguns: www.handgunbarrels.com
Bolt actions: www.700barrels.com
Foreign Semi Autos: www.akbarrels.com
Most work done while you wait on a scheduled shop visit.Comment
There are currently 13242 users online. 110 members and 13132 guests.
Most users ever online was 239,041 at 10:39 PM on 02-14-2026.
Comment