Raddlock

[E-120]

Hello, I am having trouble drilling out the rivet head of the spring catch on a Century/ Henderson WASR 10. I used the recommended 3/16 drill bit. However, I can still not get the piece out. I am afraid to over size the hole. Any suggestions would help.
Thanks

[E-120]

Well, as luck would have it I solved the problem twenty minutes later. I needed to use a chisel to take off the remaining rivet head.

[uxo2]

DOOHHH..

I would of bought and used a SOLARTACTICAL lock

[E-120]

I have a Jumbo Panda on this Lancaster pistol and it works all right. I will have to try the Solar Tactical on my M-70 project.

[SanSacto]

I have the JJPerl AK mag lock, but I was thinking about switching to the Raddlock AK mag lock. What do you think? I believe all it would take for me is to remove JJPerl's metal shrout, bolt, and nut then install the Raddlock AK mag lock. I have already removed the stock pin that holds the the mag lever in place when I installed the JJPerl AK mag lock, correct?

[E-120]

The Raddlock slides into the same hole as the original rivet, so it should not be an issue.