Tweet
Is anyone out there able to remove a silicon carbide coating on a g19 and then laser or hand stipple it?
-
-
good luck. it's epoxy with SIC sprinkled on the wet epoxy. you'd have to chip off the epoxy base -
A sandblaster would take it off but would also dull (matte) and wear on the plastic if you spend too much time blasting after the epoxy comes off.
Would be easier to buy another glock to mess with than to try to un-do the previous epoxy and SIC work.Randall Rausch
AR work: www.ar15barrels.com
Bolt actions: www.700barrels.com
Foreign Semi Autos: www.akbarrels.com
Barrel, sight and trigger work on most pistols and shotguns.
Most work performed while-you-wait.Comment
There are currently 9133 users online. 96 members and 9037 guests.
Most users ever online was 239,041 at 10:39 PM on 02-14-2026.
Comment