Tweet
As expected, it was a PITA to install the roll pins. Should these be inserted beyond the opening, or is it OK if they are flush? I was able to get the bolt catch roll pin flush with the point of insertion however the trigger guard roll pin flattened out maybe a millimeter from being flush.
I performed a function check on both (every step actually) with no issues.
I followed several online installation guides (i.e. correct punches save for the roll pin holders).
Lastly, the pivot detent spring has a minor bend where it meets the stock.
Should I order/replace these parts or am I OK? This was my first build so I expected to run into some snags.
Thanks for any and all input!
I performed a function check on both (every step actually) with no issues.
I followed several online installation guides (i.e. correct punches save for the roll pin holders).
Lastly, the pivot detent spring has a minor bend where it meets the stock.
Should I order/replace these parts or am I OK? This was my first build so I expected to run into some snags.
Thanks for any and all input!
Comment