Glock 23 trigger not resetting

[cpl_dan]

[SkyHawk]

Make sure the trigger spring is installed correctly

https://www.kingglock.com/Content.aspx?PAGE=Trigger%20Spring%20Install

and be sure that it has not slipped to the side like this

https://www.glocktalk.com/threads/advise-on-a-glock-19-gen-4.1770752/

It needs to be like this







Also make sure the striker channel is clean, dry, and the striker spring is not broken.

Start with those and get back to us if that does not resolve it

[Steve G]

Really good solutions posted by SkyHawk! Bet one of those takes care of the problem.

[cpl_dan]

Good post but trigger issue took some pics of slide and maybe issue or maybe weak striker spring?

[hermosabeach]

It happened to me. I started resetting manually - use finger tip to push forward.


Swapped on spring - back in business

[cpl_dan]

It happened to me. I started resetting manually - use finger tip to push forward.


Swapped on spring - back in business

Which spring?

[9Cal_OC]

Looks like it’s broken.

Send it to me and I’ll make sure to properly dispose it

[unclerandy]

Where are you located?

[ar15barrels]

So the Glock 23 trigger will not reset stays back and won’t come forward.
What possible issues can it be?

What parts did you change out just before the problem occurred?
Did it happen after you had the gun apart and put it back together?

[cpl_dan]

Here are some additional pictures:

1. 100% engagement , pulling trigger
2. After pulling, trigger does not reset after letting go.

[SoldierLife7]

Can you take the slide off and post a picture looking at the trigger group?

[G-forceJunkie]

Your leaving out alot of information. Like probably the fact that you have had the slide and or lowr apart. What did you do, what did you replace, what did you reassemble incorrectly?

[ar15barrels]

Here are some additional pictures:

1. 100% engagement , pulling trigger
2. After pulling, trigger does not reset after letting go.

The trigger on a glock does not "reset" until after the slide cycles.
A glock does NOT have a "repeat strike" capability like an actual double action firearm.

So do as follows:

Pull trigger.
Cycle slide.
Pull trigger.

Does it fire the 2nd time or not?

[cpl_dan]

Found issue, small burr on the rails preventing trigger bar to move freely

[SkyHawk]

Found issue, small burr on the rails preventing trigger bar to move freely

That makes no sense, considering the trigger bar has no interaction with the rails whatsoever

But if you're happy, I guess case closed.