Unconfigured Ad Widget

Collapse

Glock Trigger Locking Up

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • drewfoo
    Junior Member
    • Oct 2019
    • 48

    Glock Trigger Locking Up

    Hi -

    I have G34 Gen 5 with Ghost Rocket Connect 3.5lb installed with the rest of my springs being lightened for competition reasons. I've been noticing during dry firing that my trigger starts to tighten up - meaning that I would get to the wall and every subsequent pull it would start to get to get the trigger bar to release. If I bend the connector in a bit to give it a bit more tolerance the trigger is smooth as can be but over time it happens again. I've been noticing that there is some marks to the outside of the trigger bar (opposite of the side that touches the connector) and so I'm thinking it's rubbing against the frame. I'm not sure this is caused by the connector or trigger bar itself being bent somehow.

    Any thoughts on how I can fix this?
  • #2
    naz
    Veteran Member
    • Jun 2020
    • 3108

    How about another connector and spring set? The fact that you need to bend the connector is pretty sus

    I’ve been happy with the TTI parts in my g34 gen 3

    Comment

    • #3
      ar15barrels
      I need a LIFE!!
      • Jan 2006
      • 57199

      Originally posted by drewfoo
      Hi -

      I have G34 Gen 5 with Ghost Rocket Connect 3.5lb installed with the rest of my springs being lightened for competition reasons. I've been noticing during dry firing that my trigger starts to tighten up - meaning that I would get to the wall and every subsequent pull it would start to get to get the trigger bar to release. If I bend the connector in a bit to give it a bit more tolerance the trigger is smooth as can be but over time it happens again. I've been noticing that there is some marks to the outside of the trigger bar (opposite of the side that touches the connector) and so I'm thinking it's rubbing against the frame. I'm not sure this is caused by the connector or trigger bar itself being bent somehow.

      Any thoughts on how I can fix this?
      You should NOT be bending the connector.
      It's SUPPOSED to be sprung against the slide so that it rides the cam track in the slide.

      What you CAN do is bend the trigger bar tab that pulls the striker back up or down so that the release happens just before the trigger reaches the end of travel.
      This is assuming you don't just run an overtravel stop screw instead.
      Randall Rausch

      AR work: www.ar15barrels.com
      Handguns: www.handgunbarrels.com
      Bolt actions: www.700barrels.com
      Foreign Semi Autos: www.akbarrels.com
      Most work done while you wait on a scheduled shop visit.

      Comment

      • #4
        G-forceJunkie
        Calguns Addict
        • Jul 2010
        • 6530

        Your Glock trigger is not locking up. Your crappy aftermarket parts are locking up. The answer is simple, I bet it works fine with Glock parts in it.

        Comment

        • #5
          keith1911
          Senior Member
          • Jun 2011
          • 1297

          Sounds like either an aftermarket part problem or an installation problem.

          Comment

          Working...
          UA-8071174-1