Unconfigured Ad Widget

Collapse

Saiga scope mount help...

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • bigbob76
    Veteran Member
    • Dec 2007
    • 3954

    Saiga scope mount help...

    I posted this in the optics section and didn't get a response. I have this scope mount for my Saiga 7.62x39 and when I slide it onto the rail it seems to me it's not sliding far enough forward. I'm tempted to give it a few taps with my brass hammer. Help?
    If you can't explain it simply you don't understand it well enough. Albert Einstein
  • #2
    simon_sw
    Junior Member
    • Jun 2007
    • 65

    Bob,

    I have a mount very similar to that one. It's actually the Leapers one (which I think is not as nice as the one you have with the quick release) with the side and top picatinny rail. It got caught up about 3/4 of the way on my Saiga 308 and I just ended up getting a small rubber mallet and tapped it to fit.

    Your result may vary, but in my case it worked all right.

    Comment

    • #3
      railroader
      Veteran Member
      • Oct 2005
      • 3115

      You need to wiggle it a bit. The one I had on my saiga was the same way, it had to be just right to slide on. Mark

      Comment

      • #4
        jchen76@gmail.com
        Senior Member
        • Nov 2004
        • 2092

        Couple drops of oil on the rails and slight tap? My old saiga was tight at first, probably due to the loose tolerances of both the rail and the scope.

        Comment

        Working...
        UA-8071174-1