How to Undercut a Trigger Guard Glock 43

[thehobbygunsmith]

Hey guys i just uploaded a new video for those that are interested, i go over the process and what i do to undercut a trigger guard on a polymer frame, hope you guys like it and thanks for all the support guys i really appreciate it. on the next video i will be showing the process of texturing the frame and how i lay out all my lines. so support the channel and subscribe to keep up to date. Thanks guys.

https://youtu.be/2fsS1EItFds

[mtenenhaus]

thanks for sharing, looking forward to future installments

[ar15barrels]

It's way easier in a milling machine.



The relief should be 90 degrees to the grip frame angle so your middle finger can clear the triggergaurd as you draw.

[mtenenhaus]

AR15Barrels, thank you for sharing. How do you like the magazine release paddle? it looks very comfortable. who makes it?

[watevers1]

subscribed

[thehobbygunsmith]

thanks for sharing, looking forward to future installments

Thank You friend.

It's way easier in a milling machine.



The relief should be 90 degrees to the grip frame angle so your middle finger can clear the triggergaurd as you draw.

Definitely easier with the mill brother. looks good

subscribed

Thank You for the support friend i really appreciate it.

[ar15barrels]

AR15Barrels, thank you for sharing. How do you like the magazine release paddle? it looks very comfortable. who makes it?

I like it a lot.
It's a JP.

[scamp62]

Randall, do run that without the slide stop ?

[ar15barrels]

Randall, do run that without the slide stop ?

No.
I don't know why the slide stop is missing in the photo.
Maybe it was in the way of the vise jaws and I took it off to do the undercut and then took that photo before I put the slide stop back on...

[mtenenhaus]

it seems they've discontinued that magazine release. too bad, it looks like its broad and yet low profile