Anderson AM15 lower.. Any issues?

[Squirly]

Whats the feedback on AM15.556 stripped lower by Anderson? Any issues? Have one avail to me and want to know of this is ok for a lower cost build?
Thanks

[SkyHawk]

They are awesome. The newer ones do not have the pistol grip screw hole tapped all the way through. But it works great with Magpul grips included screw, or you can just tap it all the way, or get a shorter screw from any number of sources.

I have four or five built on them, never had any issues at all. Just as good as the Spikes I have built on.

[plumbworker]

Some I hear have had great experiences with Anderson, I have on the other hand purchased a few lowers in the past and found them to be out of spec, Specifically the buffer detent retainer holes drilled off center also the receiver - upper fitment I found is sloppy f**king loose across two lowers I had.

Other issues I found with an Anderson bcg I purchased is with the gas key fasteners I experienced breakage (after less than 100rnds) upon closer inspection it was found to have imported screws securing the key. Again some will say they have never had any issues with Anderson , I won’t be purchasing anything Anderson after my experience that’s for sure!

pumping out mass produced poor QC low quality parts from what I’ve seen

[MosinVirus]

...

[Squirly]

Alright.. 50/50 it looks like anyone break the tie?

[Cheep]

It'll work, buy it.