Are there any drawings floating around for Glock slides?

[Nelson_2016]

I wonder: What are the specs for the barrel hole in the front of the slide?

I recently bought a Lone Wolf "Alpha Wolf" Glock 19 slide and the barrel-to-slide clearance is noticeably sloppier than it is with my Glock factory slide.

A quick measurement with a digital caliper shows a diameter of about 0.575" for the glock slide and about 0.586" for the lone wolf slide. (Also, the hole in the LW slide seems slightly out-of-round).

(The diameter of the Glock 19 factory barrel measures about 0.570").

Maybe I'm being too picky, but I don't like the extra sloppiness with the LW slide.

[ar15barrels]

Since you measure your glock slide at 0.570" and 14.5mm happens to be 0.5708", I would bet that the nominal size is 14.5mm +/- whatever tolerances they assigned.
Designers like to work in nice round numbers when possible.
Nice round numbers also make it easier for the manufacturing side.

I would reject that slide as being too sloppy and send it back.

[Junkie]

11 thou is waaay off for something like that. I wonder if it's a .40 slide or something.

[Nelson_2016]

My feelings exactly. I already have it packed up and ready to be shipped back.

I'm going to call them tomorrow and see if I can exchange it for a usable slide; if not I'll get a refund and get one somewhere else.

11 thou is waaay off for something like that. I wonder if it's a .40 slide or something.