Tweet
Not sure where to start, so I figure right here is as good as any. I live in Northern California in the Stockton area. I would like a reference to good machinists that will work on a blank barrel such as chambering, cutting threads, cutting the barrel to length and finally crowning it and install in on a bolt action receiver. I found two machinists in Stockton, one guy says he's 8 months out and the other guy I'm troubled about what he said to me. I need other references if you guys can give them to me.
-
Better to have it and not need it than need it and not have it.
__________________________
ΜΟΛΩΝ ΛΑΒΕ! -
Try Randall ar15 barrels you may have to make a trip to be there while barrel installed. -
I think Kendog4570 is out that way. search him on this forum and ask him if that is in his wheelhouse. If not I know AR15barrels is capable but he is southern CA.Comment
-
Kind of a drive for you, (1hr~ over hwy 12) but try Blue Steel in Suisun, he usually takes a couple weeks, but he's reasonable. Stop by la cabana next door, killer food...But I don't come 'round here to meet nice people anyway
And what the hell am I doing drunk in the middle of the dayComment
-
Kendog4570. He is up your way,
Send him a pm.Been gone too long. It's been 15 to 20 years since i had to shelf my guns. Those early years sucked.
I really miss the good old Pomona Gun Shows.
I'm Back.Comment
-
What are you working on?Comment
There are currently 5430 users online. 200 members and 5230 guests.
Most users ever online was 65,177 at 7:20 PM on 09-21-2024.
Comment