How to remove Glock Trigger Pin

[Mac Attack]

I want to smooth up the action on my new Glock 19 Gen 4 and planned to start with a .25 cent trigger job and a Ghost connector. For the life of me I can't get the darn trigger cross pin out. I wiggled the slide stop as i pushed on the pin hard but it will not budge. I even tried using a rubber mallet and it didn't even move. I never had this problem with my other Glocks. Any advice?

[Calico1404]

Your slide stop spring may by jammed up, look inside and verify.

Its all in the wrist with the stop wiggle to get that dang pin out.

Not a Gen 4 owner, do not know if there is a specific trick. In for an answer as well.

[keith1911]

Jiggle the slide release while pushing on the pin. It's what I had to do to get the pin out of my Gen4 17 to do that $.25 trigger job.

[SkyHawk]

Whatever you do, do not try to force it out. Quickly flick the slide stop up just a bit and let it flick down, repeatedly while applying hand pressure to the pin removal tool. You can also wiggle the slide stop forward and back along the frame. It has a little room to move back and forth along the frame.

[Spyder]

Hammer and punch!!!

...if ya want to break it.

[wpage]

Punch it bubba...