Tweet
I have a medium sized- IIRC 40" bed and 12" or so swing, belt driven, old lathe that I may sell rather than move again. 110v motor and will run in a home garage if you have the room. Hollow shaft that allows threading or machining of long stock such as barrels. Its currently in storage so will be a few days before I can get it out where I can take pictures or get it to where it could be picked up, just thought I would put it out there to see if there is interest in it.
US made, I bought it from a helicopter engine service center that used it for rough machining in thier welding shop, I have had it about three or four years.
Again it will be days before I can get pics or it could be looked at, but I am seriously considering selling it. Asking price will be in the $900 range I think.
US made, I bought it from a helicopter engine service center that used it for rough machining in thier welding shop, I have had it about three or four years.
Again it will be days before I can get pics or it could be looked at, but I am seriously considering selling it. Asking price will be in the $900 range I think.
Comment