Need mill work--AICS chassis

[jmsdad]

Looking for someone with a mill to open up the recoil lug recess on an AICS chassis. My barreled action has a .300" thick recoil lug and the recoil lug recess on the AICS chassis measured .250" thick. SF bay area preferred but can travel to SAC down to Fresno and the Sierra foothills.



--Mill out green area...

[ar15barrels]

That work is usually done by the guy that put the lug between the barrel and receiver.
This is also why I always tell people to get a 0.228" thick lug.
A 0.228" lug fits every stock...

[Hateca]

Chances are your recoil lug is too tall as well. If it is you will need someone to mill the bottom off the lug. Do not cut deeper into the stock.

[kendog4570]

[QUOTE=jmsdad;18619734]Looking for someone with a mill to open up the recoil lug recess on an AICS chassis. My barreled action has a .300" thick recoil lug and the recoil lug recess on the AICS chassis measured .250" thick. SF bay area preferred but can travel to SAC down to Fresno and the Sierra foothills.



I am in Oakhurst. In the Sierras approx 45 miles NE of Fresno near Bass Lake. Like Hateca says, probably needs a little carving on both. Cheaper to ship it than a road trip.