Engraving for blank lower -SN etc.

[zvardan]

I have a lower that I milled from an 80% back in 2012. It's blank.

Is there someone in the Bay Area that can engrave a serial number and any other pertinent information as required by federal law? Just trying to get this done so I can register it when the time comes.

Any help appreciated.

[TATER313]

There is a guy in lodi $125 for engraving. I send mine off to vadertactical before I mill them $60.

[38superdupper]

Carrillo Customs Inc. In Lodi will engrave basic required make, model, ser# ect. for $50. $125 is for artwork on both magwells and basic requirements. Same price for finished or non finished 80%er. And he'll engrave it while you wait.