Golani (galils) muzzle break Q's

[ETD1010]

So I really need to remove the flash hider on a golani, and my goal is to replace it with an extended one in order to drill out the pinned stock and use it normally. Problem is..... I have little to no idea what the threading is on the bbl, so I have no idea what brake's will work.... As for removal of the old brake, that's a whole different story.... Your help is greatly appreciated

~Eric

[JamesY]

You can buy a muzzle break like this one to make the OAL over the 36" min.

[ETD1010]

You can buy a muzzle break like this one to make the OAL over the 36" min.

36"? U I thought it was 30"

I saw that one, but it says it's for the SAR rifle.. not sure if that one fits? PLus, they want $14 for shipping!!

[Fjold]

30" minimum overall length for CA AW law

[saki302]

The listed brake will fit- it is standard 13mm Galil thread.

Remember, the Galil has standard, not reverse threading.

-Dave

[JamesY]

30" minimum overall length for CA AW law

I stand corrected.

[ETD1010]

The listed brake will fit- it is standard 13mm Galil thread.

Remember, the Galil has standard, not reverse threading.

-Dave

lol... that would explain the broken wrench. . . i thought they were reverse threads....

ROUND 2!!

Thanks for the help!

[saki302]

lol... that would explain the broken wrench. . . i thought they were reverse threads....

ROUND 2!!

Thanks for the help!

DOH!!!! I got to handle one at the SAR show in Phoenix- the FH spun off by hand- I just re-tightened it, probably tighter than it was

-Dave