3/4 24 muzzle brake threading

[morepoop4u]

Whats the minimum diameter needed to thread a 3/4 24 muzzle break

[kcstott]

google thread minor diameter

[zomie]

I print the following out and keep them in my toolbox:

http://angel-strike.com/wiki/index.php?title=Screw_Chart

BTW I would suggest a copy of the following:

http://www.amazon.com/Machinerys-Handbook-29th-Erik-Oberg/dp/083112900X

Which would contain this kind of information.

[kcstott]

I print the following out and keep them in my toolbox:

http://angel-strike.com/wiki/index.php?title=Screw_Chart

BTW I would suggest a copy of the following:

http://www.amazon.com/Machinerys-Handbook-29th-Erik-Oberg/dp/083112900X

Which would contain this kind of information.

Yeah but he's to lazy to bother to even look. You think he's going to buy a book and read it??? Not likely

[morepoop4u]

I print the following out and keep them in my toolbox:

http://angel-strike.com/wiki/index.php?title=Screw_Chart

BTW I would suggest a copy of the following:

http://www.amazon.com/Machinerys-Handbook-29th-Erik-Oberg/dp/083112900X

Which would contain this kind of information.

Thanks.

Googled it only saw up to 3/4 -16 in the tables. Just wanted to double check.

[kcstott]

here you go

[ar15barrels]

Whats the minimum diameter needed to thread a 3/4 24 muzzle break

My recommendation is 7/8" muzzle diameter to cut 3/4" threads.
This leaves you a 1/16" shoulder for the muzzle device to tighten against.