Tweet
I'm looking for a 9mm ejector that is oversize in the front and rear, and also in the rear area shown in the picture below in red:
Preferably I would like an ejector that does not have this area in red scalloped or machined to clear the hammer, so I can file it myself to line up with the frame and slide. It might all be for appearances and aesthetics (in addition to hammer clearance), but I want to make my first self-built 1911 right from the start...
The ejector I currently have is from EGW, and while the front and rear is good to go, the hammer clearance area is cut too much. I'm looking for the end result to be like this below, minus the rear serrations:
Thanks.
Preferably I would like an ejector that does not have this area in red scalloped or machined to clear the hammer, so I can file it myself to line up with the frame and slide. It might all be for appearances and aesthetics (in addition to hammer clearance), but I want to make my first self-built 1911 right from the start...
The ejector I currently have is from EGW, and while the front and rear is good to go, the hammer clearance area is cut too much. I'm looking for the end result to be like this below, minus the rear serrations:Thanks.
Comment