Unconfigured Ad Widget

Collapse

Surface rust

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • KrizB
    Senior Member
    • Jul 2006
    • 728

    Surface rust

    A few days ago while cleaning my Yugo 59/66, noticed under an LED light a thin layer of rust on everything forward of the receiver (barrel exterior, front/rear sights, bayo lug, etc). The rust is thin enough that it comes off with WD-40 and a brush/pad but I can't get into every little nook and cranny.

    Will a spray on rust remover or gel be fine to use?

    Any help is greatly appreciated

    *Barrel is not chromed- '69 Yugo
  • #2
    Beelzy
    Calguns Addict
    • Apr 2008
    • 9225

    Do not use rust remover. It is an acid, and if it doesn't mess up the finish
    you have to wash the gun with water to dilute it after cleaning.

    Soak the offendig areas in a gun oil/cleaning solvent mix.
    "I kill things for a living, don't make yourself one of them"

    Comment

    • #3
      AaronHorrocks
      Senior Member
      • Jan 2007
      • 1944

      Sounds like you shot corrosive ammo and didn't clean it.
      Shame on you!

      Seriously, just pick up some KleenBore #10 and go to town with it.
      Originally posted by nick
      Are there any times when you don't have a loaded firearm within reach?
      Originally posted by M. Sage
      I support violence against communists.

      Comment

      • #4
        KrizB
        Senior Member
        • Jul 2006
        • 728

        It's the outside of the gun that is covered in a thin layer of rust, the inside of the barrel is nice and clean.

        Comment

        • #5
          AaronHorrocks
          Senior Member
          • Jan 2007
          • 1944

          Yep same thing happend to my 1944 Mosin Nagant when I shot some 1940s ammo. The barrel was fine, but not the rest of the rifle from bolt to muzzle.
          Originally posted by nick
          Are there any times when you don't have a loaded firearm within reach?
          Originally posted by M. Sage
          I support violence against communists.

          Comment

          • #6
            KrizB
            Senior Member
            • Jul 2006
            • 728

            It was rusted when I bought it, just never noticed until I broke it down to get the cosmoline out and looked closer under a good light.
            Haven't even fired it yet (ammo prices) .

            Guess I'll go buy a copper brush and more oil.

            Thanks for the advice guys.

            Comment

            Working...
            UA-8071174-1