I see on AR barrels they have a shoulder that the threads come up to. I'm assuming that as you torque down on a muzzle device this is what the crush washer or shims meet. What happens without that shoulder? will a muzzle device thread on and as you twist it up the threads will it stop when the threads stop? Or will it continue on the barrel?
I'm looking to get an ak barrel cut, crowned and rethreaded but don't want to pin/weld the muzzle device on. The Barrel itself i still over 16 inches after I cut and rethread. Any solution to this? Or without a shoulder I have to pin/weld? Thanks!
I'm looking to get an ak barrel cut, crowned and rethreaded but don't want to pin/weld the muzzle device on. The Barrel itself i still over 16 inches after I cut and rethread. Any solution to this? Or without a shoulder I have to pin/weld? Thanks!

Comment