Unconfigured Ad Widget

Collapse

Case Gauge Question

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Erik16
    CGN/CGSSA Contributor
    CGN Contributor
    • Dec 2012
    • 422

    Case Gauge Question

    I want to make sure I am resizing my brass correctly. When I drop my resized .223 in my dillion case gauge it seems to be below the high step and above the low step.


    When I check a new unfired PMC .223 and a new Federal Premuim .308 in their respective case gauges they both seem to be level with the Low Step on the case gauge. Am I not resizing them correctly? My dillion die is almost touching the case plate. Pictures are not that good, sorry.


    NRA Life Member
  • #2
    maxx03
    Senior Member
    • Oct 2012
    • 1423

    Anywhere between the bottom step and top step is GTG.
    The reason for factory ammo being closer to the bottom step is because the shoulders are bumped further back to chamber in all firearms.

    Comment

    • #3
      ar15barrels
      I need a LIFE!!
      • Jan 2006
      • 57199

      Originally posted by Erik16
      I want to make sure I am resizing my brass correctly. When I drop my resized .223 in my dillion case gauge it seems to be below the high step and above the low step.

      Drop a fired case from your rifle into the gauge and see where it lands.
      Adjust your dies so that the sized cases are 0.003" shorter than your fired cases.
      Randall Rausch

      AR work: www.ar15barrels.com
      Handguns: www.handgunbarrels.com
      Bolt actions: www.700barrels.com
      Foreign Semi Autos: www.akbarrels.com
      Most work done while you wait on a scheduled shop visit.

      Comment

      Working...
      UA-8071174-1