I want to throw 3.1gr of Titegroup using my Lee Pro Auto Disk, but the smallest disk throws 3.3gr, and the Adjustable Charge Bar won't throw reliably at such a small a charge.
Adjusting a disk hole to throw a larger charge is no big deal, but making a hole throw a smaller charge is trickier. I've seen some people drill and tap the disk and add a small adjusting screw, and I've seen others put tape inside the hole. I looked into buying a Micro Disk, but it's discontinued, and the ones on eBay are going for $40.
Then I remembered I have a 3D printer at work! I designed a bushing that fits into the largest disk with a light press fit, and I can vary the hole diameter of the bushing in increments of .0006" (the resolution of the printer) to fine tune any charge I want.
Now my measure is throwing 3.1+/-.1gr. Science!
Adjusting a disk hole to throw a larger charge is no big deal, but making a hole throw a smaller charge is trickier. I've seen some people drill and tap the disk and add a small adjusting screw, and I've seen others put tape inside the hole. I looked into buying a Micro Disk, but it's discontinued, and the ones on eBay are going for $40.
Then I remembered I have a 3D printer at work! I designed a bushing that fits into the largest disk with a light press fit, and I can vary the hole diameter of the bushing in increments of .0006" (the resolution of the printer) to fine tune any charge I want.
Now my measure is throwing 3.1+/-.1gr. Science!


Comment