Unconfigured Ad Widget

Collapse

Loading 00 Buck loads

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • punkur67
    Member
    • Jan 2010
    • 312

    Loading 00 Buck loads

    I already load shotgun but want to make some 00 buck stuff. I can not find any recipies from reptubale sites. Does anyone have any links to manufacturer sites that have load data. I usually use AA and federal gold metal hulls and hodgon powders. I found the lead just not anything else.
  • #2
    3006mv
    Senior Member
    • Aug 2006
    • 1979

    Google is your friend, I like this one
    "when I hear 'meat is murder' (sic) I think murder is delicious" - Stephen Colbert interview with Morrisey 09.10.12

    I plead the 2nd.

    Comment

    • #3
      punkur67
      Member
      • Jan 2010
      • 312

      Had a friend forward me this. I should have asked what wads to use and the weight of shot. Hope this helps others:

      If you want maximum capacity in a readily available wad the Remington RP12 wad has a longer cup (to protect the pellets) and a short crush section. The WW12R equivalent from Claybuster also has a short crush section but the shotcup is not as large, leading to more buckshot bore scrub.....but it is indeed commonly used, especially in Lyman's data.

      Thing is, though, that if you're looking to just practice, a 1 1/8 ounce capacity wad fits a typical load of 9 "0" buck in layers of three for a one ounce load, or the same number of #1 buck for a bit less than a 7/8 ounce load. These are economical on lead and easier on recoil loaded to the 1150 fps range. The charge would also be smaller than the typical 27 pellet #4 load when used with this wad; but the weight would also approximate 1 ounce.

      9 "0" buck fit much better in most 1 1/8 ounce wads than 9 "00" buck do, as the fit laterally is rather tight. Just a comment based on experience.

      20 #4 buck weigh a little less than 1 ounce; the weight is between 7/8 and 1 ounce, being closer to 7/8 ounce. 27 #4 buck equate to 1 1/4 ounces.

      If you're practicing, fewer pellets aren't a handicap. More might be better for more serious use.

      So, for practicality's sake I'd say the 1 1/8 ounce wad is the choice, whether it's the WAA12, the WT12, or its Claybuster or other brand equivalent.

      However, if you want to experiment, and don't care if your handloads are economical or not, or light recoiling and miserly on lead, first figure out exactly how you want to load and how many pellets you plan on shooting and peruse some loading manuals to find what you need. If you want maximum capacity, and the most number of loads in a wide variety of hulls the Claybuster WAA12R clone is a good choice, with the catch that protection of the buckshot is less than it could be. If maximum capacity and shot protection is important, with fewer loads offered (but something you want can probably be found) then it's the RP12.

      Comment

      Working...
      UA-8071174-1