38 Carbide Dies

[pagedeveloper]

Good Morning...

OK.. I got a set of RCBS 38 Carbide dies in a trade. I had just started to use them, and now I have a issue with the pin getting stuck in the case, and being pulled out. Do I have the pin to far down, or ???

I have been able to get it out each time, but I am not looking to be doing that all the time. I think that I have fixed it, currently being used and not falling out. So if any one could put some light on it, that would help..

['ol shooter]

The pin should just knock the primer out, and should be good and tight in the die. Since I tumble my brass with the primers out, I use a universal de-capping die. Merry Christmas.

[koehn,jim]

You might also trim the diam. of the pin by a thousand or so.

[bitethebullet]

Pin should only be sticking out of the die 1/8 -3/16. It may be sticking down to far

[Bt Doctur]

there are 2 sizes of de-capping pins.

[hoisumguo]

Check to see if either the pin or the pin rod is bent or not set straight.

-Hoi