Giraud is on the way...

[armyguy209]

I ordered mine on August 21st. And you will get a random charge when it ships. I am sure you could pay up front though. The time on the website says 12 weeks but mine only took about 9.

[thmpr]

Got three trimmers and an annealer... One you go Giraud, the rest are just a memory....Great product but the price did go up a bit in the past 2 years.

[Germz]

woohoo the powers to be have decided that I will be getting one in .223 and a 300 black shellholder as well!

[armyguy209]

Nice man..

One thing I asked when I ordered was about the caliber changes. There are two ways of going about it. One is that you can change out just the cutter assembly but there is a lot of adjusting and trial and error to be done going that route. The other is to get the case holder with cutter assembly. Supposedly there is no adjusting this way. Just a simple swap out and your done.

[anyracoon]

3 separate cutters here, make caliber swap less than 5 minutes.

[popeye4]

A Giraud may not make case trimming fun, but it sure is less painful! You'll wonder why you didn't get one earlier.

You should trim AFTER you size, so if you size properly so that your shoulder is consistent, your trimmed case length will be consistent.

[FLIGHT762]

3 separate cutters here, make caliber swap less than 5 minutes.

Exactly, I bought pre set cutters in 30,22,26 and 27 calibers. I have shell holders in 223 Remington, 260 Remington, 270 Winchester, 308 Winchester and
30/06. Swap time with pre set lock rings on the shell holders is about 2 minutes. I love my Giraud.

I have owned the Dillon RT 1200 and a Gracey. The Giraud is the best for me since I reload on single stage presses.