I was running some brass through my Lee FL sizing die and did this:

I think the culprit was, well me and in part this berdan case that slipped in:

I gave it way too much force thinking I may have not lubed a case enough. Not paying attention to the output, about 5-6 cases were crunched thereafter where the casemouth was smashed into the shoulder.
So two questions; 1) The decapping rod needs to be replaced right? and 2) What is the realistic amount of force required to resize?

I think the culprit was, well me and in part this berdan case that slipped in:

I gave it way too much force thinking I may have not lubed a case enough. Not paying attention to the output, about 5-6 cases were crunched thereafter where the casemouth was smashed into the shoulder.
So two questions; 1) The decapping rod needs to be replaced right? and 2) What is the realistic amount of force required to resize?



Bob B. 
Comment