Bullet Puller help idea

[drkphibr]

Sometimes the inertia bullet puller is just the right tool. I used to load up my bullet and then squat down on the garage floor for a a few hits on the concrete. Once or twice not a big deal, but more than 5 (e.g., someone else's reloads, a big batch mistake, bullet too big for the collet puller, etc.) and doing squats all night has you feeling it the next morning.

Didn't want to smack my bench (beat up the wood as well as drive the digital scale bonkers), so I came up with this idea. Scrap pieces of steel, painted with truck bed liner and put it on my bench. Now I use the inertia puller standing and hitting the 35lb steel stump isolates all the impact. Has worked out great for me and no more squats!

[Ghost_Maker]

Lmao i just did 3600 rounds of bad baatch 223..... find a nice lil stool and grab a seat cuz thats ya best bet

[50BMGBOB]

Not bad. I have a 175lbs anvil next to my workbench for the same thing. Actually I use it for many things but that is one of them. How does your scale like the vibration now? If it still bounces, you can add a bar under your blocks so it mounts to the floor not sits on you bench, even if it ties to the front edge of your bench.

[alfred1222]

Hornady collet bullet puller...??0

[RogueSniper]

What I don't like is the flakes of powder bouncing out. Any solution to that? I thought about wrapping a plastic bag around the inertia hammer.

[ExtremeX]

What I don't like is the flakes of powder bouncing out. Any solution to that? I thought about wrapping a plastic bag around the inertia hammer.

I use a small 2x2" peice of plastic bag over the bullet and collet before I tighten down the plastic cap... works like a charm.

[ExtremeX]

Lmao i just did 3600 rounds of bad baatch 223..... find a nice lil stool and grab a seat cuz thats ya best bet

thats a lot of rounds in a bad batch...

hope I never have to do that.

[drkphibr]

Not bad. I have a 175lbs anvil next to my workbench for the same thing. Actually I use it for many things but that is one of them. How does your scale like the vibration now? If it still bounces, you can add a bar under your blocks so it mounts to the floor not sits on you bench, even if it ties to the front edge of your bench.

I put rubber "feet" under it and that took care of the vibrations.

Hornady collet bullet puller...??0

Don't have all the collet sizes and setting it up for a pull here and there isn't worth the time.

What I don't like is the flakes of powder bouncing out. Any solution to that? I thought about wrapping a plastic bag around the inertia hammer.

I put a piece of tape around the back of my intertia puller to prevent powder from "flying"...