Need Help with RCBS Trim Pro 2

[Tnavres]

This is my first trimmer and I have a few problems.

First when I push the lever down the holder moves towards the cutter but the brass will not go on. the book says to push the brass back and then down, but it doesn't matter what I the case will not go on correctly.

I can put the case into the hold spring clams by sliding the brass in sideways. When I do this and I try to trim the case the brass spins with the cutter head and doesn't cut.

Those are my main two problems. I also have somehow gotten the fine adjustment stuck to the coarse adjustment, and the set screws look like they will stand a few more adjustmets before they become stripped.

Thanks for any help.

[stevec223]

trim

turn the case holder around....the flatest side toward the handle...push down on handle and put case head between the case holder and the wall behind it...should fold firm...watch out for the 2 pin heads as they sometimes get cocked and 1 will pop out of caseholder....cheers...

[Sub95]

Picture of how it should be.