Been shooting my dad's 4506-1 a fair amount lately with factory 230 RN and my reload using xtreme 230 plated RN, W231 @ 5.2 and OAL at 1.26". These all have functioned flawlessly. I just made some test loads using xtreme 200 plated RN, W231 @ 5.0 and OAL 1.25".
The 200 gr didn't perform. I believe the issue is referred to as failure to eject and all the cases were holding the slide open and parallel to the barrel? After one clip, having the issue consistently, I put those away for now, although some did cycle as well.
Is this problem what is referred to as a failure to eject?
My guess is that they will cycle if I use a reduced recoil spring? Or, up the 231 powder in another test batch?
I assume the OAL of 1.25" isn't an issue since the 1.26" works fine?
Thanks!
The 200 gr didn't perform. I believe the issue is referred to as failure to eject and all the cases were holding the slide open and parallel to the barrel? After one clip, having the issue consistently, I put those away for now, although some did cycle as well.
Is this problem what is referred to as a failure to eject?
My guess is that they will cycle if I use a reduced recoil spring? Or, up the 231 powder in another test batch?
I assume the OAL of 1.25" isn't an issue since the 1.26" works fine?
Thanks!


CA: Exorcising my 2A rights
Comment