Lock N Load Powder Measure

[SandDiegoDuner]

Hey Bob,

I live just outside of Poway and I am willing to bring my LNL AP by your place so you can visually compare your press to mine. I think your cam wire is not aligned properly from what I am reading. I should be free Saturday morning/early afternoon if you need the help.

Paul

[KB1911_NewB]

More problems. THE cam wire started lifting out of the cup because the upper bracket was flexing (so I thought). I fashioned a stiffener to keep the bracket from flexing and this worked for maybe 50 rounds or so, then the little axle on the primer shuttle pulled out.

I have noticed the primer shuttle spring contacts the upright of the cast frame pretty significantly.
Anyone have any ideas? Fyathyrio?

I think there is something wrong with the basic timing of things in the press but I am not savvy enough to figure out the problem.

I did email Hornady but have not heard anything yet.

If the roller pin is lose, it will allow the spring to make contact with the frame. A tiny drop of super glue should fix the pin issue but make sure to keep the glue clear of the roller. You might have other issue with your setup so this won't last long before something else breaks.

Are you sure the cam wire plastic bracket is adjusted / aligned correctly?