Hi Tech .223 62gr. Pulled and resized bullets any good?

[echo884]

Hi, this might be a repeat, but I couldn't find it.

I usually get my 62gr from goldenwestbrass.com, but have been out of stock forever. Are the Hi-tech Ammo 62gr "machine pulled and resized" bullets any good? Mostly want a good plinking round.

Thanks!

[troysland]

I'm curious too, I see pulled bullets more readily available. Are these factory loads that didn't meet OAL specs?

[NotEnufGarage]

I've had good luck so far with pulled 62's. I got them from Rocky Mountain Reloading.

[anyracoon]

For blasting, plinking, SHTF fine. If you are looking for 1 MOA at a hundred yards load up something different.

[the86d]

I bought these from them, and I had no problems. These were my 1st reloads.

I also bought some NEW 55 grain from www.rvow.com and they sent me factory seconds instead.
The crimp ring around the projectile varied from bullet to bullet quite a bit, but they shot VERY well anyway.

[9mmrevolver]

That's all I use for plinking. Never shot them for accuracy though. I could hit cans with them. Just try to leave me some

[luchador768]

I picked up 5k from TopBrass. Most of the 2k I've loaded have little to no damage from being pulled. I've fired about 5-600 and they are plenty accurate for plinking.