Ammo Brothers .40S&W Reloads

[deoxys987]

I was at ammo bros and they had 250 rounds of .40S&W Reloads for 67.99 and 100 round boxes of their reloads for 27.99 I bought a box of the 250 40S&W reloads for 67.99$ is that a good price? I opened the box and it's a mix of Federal and Winchester reloads. Did I do good for 67$??
I can't wait to try these out at the range in my new G22!

[AGGRESSOR]

Don't shoot reloads in your Glock, especially 40 S&W. Unless Glock changed their Barrels, your Glock's barrel chamber is "unsupported". Not all Glocks blowup, but, you don't want to be that one that does blowup.

[deoxys987]

It's a Gen 4 Glock 22. It's different barrel and design to incorporate the dual recoil spring in the assembly.
AGGRESSOR, I used .45 reloads in s G21 with no issues..

[Ackrite]

I've used thousands of Ammo Bros .40 reloads in my Glock 23 with no issues. When it did almost blow up it was with somebody else's unknown reloads. I use their reloads in my G17 and G30 as well, no problems.

[SublimeJJ99]

Don't shoot reloads in your Glock, especially 40 S&W. Unless Glock changed their Barrels, your Glock's barrel chamber is "unsupported". Not all Glocks blowup, but, you don't want to be that one that does blowup.

+1 Glock factory barrels don't fully support the case and thus may have a problem with reloads. They also have major case bulge for the same reason. I can tell when a .40 S&W brass has been fire from a glock because of this bulge. I pick them up and end up tossing them. I would refrain from shooting reloads through your glock unless you put an aftermarket barrel the fully supports the case in it.

Sent from my SPH-D700 using Tapatalk 2

[SwPx4]

Price is a little high IMO.. not too bad though.

[AGGRESSOR]

Hi Deoxys987, I didn't see you have a "NEW G22". I have a 1st Gen. G23 and the case sticks out too far out of the chamber. In my case, I wouldn't fire reloads. Also, .40 S&W is a high pressure load compared to the .45 ACP or 9 MM. You'll find more bulged .40 S&W cases than the .45 ACP or 9MM.

[deoxys987]

Hi Deoxys987, I didn't see you have a "NEW G22". I have a 1st Gen. G23 and the case sticks out too far out of the chamber. In my case, I wouldn't fire reloads. Also, .40 S&W is a high pressure load compared to the .45 ACP or 9 MM. You'll find more bulged .40 S&W cases than the .45 ACP or 9MM.

Yep my G22 is a Gen 4 and brand new, thursday will be the first time I get to take it to the range, it should be fine and I didn't notice any bulges in the ammunition cases. All of the ammo looks like it's never fired brass because everythings shiny and looks nice