...
Unconfigured Ad Widget
Collapse
|
|
|
|
|
|
|
|
.
Collapse
X
-
Tags: None
-
Others will say it too - if you have a 10mm, reloading will be your friend. It's not impossible to find 10mm over the counter but when you do, it can get expensive. If you're not planning to reload, online shopping is the way to go.NRA Life Member -
You CAN spend $1000 but you can also get into reloading for way less than $1k, It all depends on what you are willing to spend to do it. You are only limited by your budget.
The best way to start though is buy some factory loaded brass case ammo, then once you shoot it you have the brass to reload with.
If you decide you want to reload, and don't have any clue where to start. You are welcome to get ahold of me, I am just down the road from you in Tulare.Some people talk about it and some people do it.Comment
-
$110
Carbide dies for 10mm, which means no lubricant required:
$38.50
For that matter, the remaining carbon on the cases if you don't clean them is pretty good lube for carbide dies.
So, that's the hardware to reload 10mm, then you need the consumables. Primers, powder and bullets from Easley's is the easiest way to get started, you don't want to get hit with $20 hazmat for a single pound of powder or a single box of 1000 primers. This will make your initial reloads a bit more spendy, but you can buy 8lb jugs and 5000 primer cases later when you're in the reloading groove.
Whoever told you $1K to start reloading was on an ego trip driven by his/her Dillon setup, not by common sense. Find other advisors.
Regards,
Brian in CAComment
Calguns.net Statistics
Collapse
Topics: 1,870,695
Posts: 25,175,038
Members: 358,862
Active Members: 5,389
Welcome to our newest member, 1776 Arms.
What's Going On
Collapse
There are currently 20191 users online. 147 members and 20044 guests.
Most users ever online was 239,041 at 11:39 PM on 02-14-2026.

Comment