Unconfigured Ad Widget

Collapse

Trim before Full length sizing?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Quinc
    Veteran Member
    • Jan 2010
    • 3011

    Trim before Full length sizing?

    Sorry full all this questions but I am new to reloading.

    I was under the impression that I should FL size and then trim. However, Foresters instructions say to trim first then FL size. This doesn't seem right to me since sizing will most likely change the case length?

    This is for .223
    Shop Amazon and contribute to CGF!
    click this link before going to amazon.com
    http://www.shop42a.com

    sigpic
    www.appleseedinfo.org

    "Everyone has a plan, till they get punched in the face." -Mike Tyson
  • #2
    epcii
    Senior Member
    • Feb 2011
    • 637

    I would still trim afterward.
    sigpic
    Ask not for a lighter burden, but for broader shoulders
    NRA Member

    Comment

    • #3
      gau17
      Senior Member
      • Jul 2009
      • 846

      Always size first before trimming.
      Semper Fi

      IYAOYAS

      Comment

      • #4
        rsrocket1
        Veteran Member
        • Feb 2010
        • 2774

        Typically, when you full lenght size a rifle case, you oversqueeze the neck and the expander ball opens it up as you pull the case from the die. This causes stretching of the neck. That's why you want to trim after full length resizing.

        When neck sizing only, you are just squeezing the neck back to where it puts adequate tension on the bullet. No stretching of the neck so usually no triming needed either.

        Comment

        • #5
          24Sailor
          Senior Member
          • May 2011
          • 937

          Originally posted by Quinc
          Sorry full all this questions but I am new to reloading.

          I was under the impression that I should FL size and then trim. However, Foresters instructions say to trim first then FL size. This doesn't seem right to me since sizing will most likely change the case length?

          This is for .223
          If Forester dies are similar to RCBS X-dies then the sequence goes somewhat like this FL size, trim, adjust FL X-die spindle down to stop and size again....Confusing to me too.....and I've been doing this for years.

          Comment

          Working...
          UA-8071174-1