Unconfigured Ad Widget

Collapse

shot press help

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • BP707
    Junior Member
    • Jan 2011
    • 89

    shot press help

    I bought a MEC 9000 press a few weeks ago got it dialed in, but it seems randomly it will crush the bottom the hulll in the depriming stage what will cause this?
  • #2
    Revoman
    Senior Member
    • Dec 2007
    • 2394

    IIRC, the 9000 has the sizer at position one, if the shell/hull isn't all the way down into the sizer, it will crush the base.
    The fingers that do the sizing are shaped exactly like the brass portion of the hull, including the head which has the flare at the very bottom. It sounds like you are not setting the hull completely into the sizer and the fingers are sizing the flared part. This would easily crush the hull, especially if you have hydraulics.
    I think also that there should be a spacer in the center of the fingers, which holds the hull in the correct position. (It resembles a golf tee, but is a hollow tube with a 'washer' top.) If the press has been turned upside-down, that spacer can fall out since it's not held in by any means.
    Sometimes the fingers need lubrication as they do get hot when going at it reloading. Perhaps they are not returning fully open and preventing the hull from dropping completely in.

    Those are my guesses anyway.

    Comment

    • #3
      mjsweims
      Senior Member
      • May 2009
      • 807

      If what revoman doesn't help try calling or emailing MEC. They're great to work with and generally will be able to help you out without selling you anything.
      Jack

      sigpic

      Comment

      Working...
      UA-8071174-1