Tweet
Brand new Remington 260 brass. I always run new brass through the sizer to iron out any mouth dents, etc. I don't think this one is going to work though.
-
Frank
One rifle, one planet, Holland's 375
Life Member NRA, CRPA and SAF -
Whoops....
Try some Lapua .260 brass. -
Just for giggles, send it back to Remington with your return address...it'd be nice to see their response
Comment
-
I'd use it...Comment
-
That'll buff right out!Actually I only started collecting Milsurps 3 years ago. I think I might own about 24...They're cheaper than guns that will most likely never get the opportunity to kill somebody...
I belong to the group that uses firearms, and knows which bathroom to use.
Tis better to have Trolled & lost, Than to never have Trolled, at all.
Secret Club Member?.Comment
-
I have some new 7.5x55 brass from PRVI that had some creased shoulders and other defects I didn't care to spend my money on. I just used them for dummy rounds and to find the proper seating depth for different bullets.Comment
-
At least they all have flash holes...Comment
-
I agree with checking new brass. Even automated machines that manufactures brass can screw up like humans. Good advice for anyone.Last edited by ireload; 08-29-2011, 5:22 AM.Comment
There are currently 11746 users online. 50 members and 11696 guests.
Most users ever online was 239,041 at 10:39 PM on 02-14-2026.
Comment