Tweet
I am in the process of rebuilding one of these and have a compatibility question. Can anyone measure the distance from the top of the shellplate platform to the bottom the press where the dies thread in? I am trying to see if I can use this press with C4H 300 Whisper trim die and Dillon 1200B Trimmer.
-
Visit my page at www.echoarms.com for casting, reloading, and firearms accessories.
Like my Facebook page: Echo Arms -
4.35" on my 450BFrank
One rifle, one planet, Holland's 375
Life Member NRA, CRPA and SAF -
I'm dumb. I should have asked for the distance with the ram all the way up. Thanks so much.Visit my page at www.echoarms.com for casting, reloading, and firearms accessories.
Like my Facebook page: Echo ArmsComment
-
With the ram at the top of the stroke:
From the bottom side of the top of the frame, (the milled section) to the top of the fixed plate is .805".
From the bottom side of the top of the frame to the top of the rotating plate (where it's cut out for the dies) is .675".Frank
One rifle, one planet, Holland's 375
Life Member NRA, CRPA and SAFComment
There are currently 7715 users online. 37 members and 7678 guests.
Most users ever online was 239,041 at 10:39 PM on 02-14-2026.
Comment