New Addition To Reloading Bench

[sfonelson]

I upgraded my trimming/chafur/deburring configuration from a possum hollow trimmer and RCBS chamfer/deburring tools chucked into a drill to this RCBS Trim Pro manual Trimmer.

http://www.midwayusa.com/viewproduct/?productnumber=114864&cm_mmc=Froogle-_-Reloading%20-%20Metallic%20Reloading%20Equipment%20(Not%20Presses)-_-PriceCompListing-_-114864

I also purchased the three way cutter for .22 and 30-06, and the power drill adapter.

Received everything last night and put it together. The three way cutter was kind of hard to get used too. It required a lot of adjustments to get the bevels right for the chamfer and deburr. After getting the trimming head setup though, I don't plan on having to mess with it too often.

One thing I noticed though, is after a few trims, my cases were getting trimmed shorter and shorter. I really had to tighten down the trim length adjustments on the trimmer. So far though, I highly recommend it. It sure is nice to do everything in one step with the cases, rather than trim 200, switch tools, chamfer 200, and so on. One step for everything is great.

[damndave]

I just purchased the Forster 3 in 1 trimmer, chamfer and deburring tool as well. It should be here today sometime. It connects right with my Forster Original Trimmer and Power Adapter. Hopefully mine isn't that hard to setup.

[sfonelson]

Nice, I saw that video on that other trimming thread. I'm interested to hear your take on it. I plan on prepping a couple hundred cases tonight. Maybe after I break it in a little it will start being more consistent. It's just plinkin' ammo, so I'm not that concerned.